Sutherland Little Loco Mk2
phono preamplifier


Sutherland Little Loco Mk2 Design Philosophy

You may have noticed a new kind of phono preamp design on the market—usually referred to as ‘current input’. Until recently, this approach has been very much in the background. But, listeners and reviewers are now giving it some serious consideration. And many love what they hear.

The Sutherland little LOCO is Sutherland’s realization of this approach. From the first moments of listening, the musicality is stunning—spacious, effortless & full.

 

The original little LOCO had an essentially balanced input signal requirement. The signal came in on both the RCA center pin and the RCA shell. There was a strict requirement that the RCA shell float above ground.

The newly designed Mk2 trans-impedance input stage is now single ended. The signal comes in on the RCA center pin. The RCA shell is at ground level.

Sutherland Little LOCO Mk2 presents a virtual short as the cartridge load.

Instead of voltage being the input parameter, it is the current generated by the cartridge that conveys musical content.

The endless worry about finding the ‘best’ load value is eliminated.

The cartridge must be the moving coil type.

Those with low output will be embraced. Not compatible with moving magnet or moving iron or step-up-transformers.

Thanks to the new little LOCO Mk2 circuit, the shell of the RCA input jack is now at ground. There are no special TT cable requirements.

sutherland little loko mk2 gain section

Sutherland Little Loco GAIN SETTINGS

The Little LOCO Mk2 is factory-set to medium gain. That should work very well in most situations.

The usual concerns about cartridge output voltage do not apply here. Cartridges of varied output voltage specs tend to supply about the same level of drive current into a short. i.e. higher output voltages usually have an associated higher internal resistance. Lower output voltages usually have an associated lower internal resistance.

Sutherland Little Loco LOAD SETTINGS

There are no loading adjustments in the little LOCO Mk2.

Your cartridge will see a load of zero Ohms. The input signal will be the current your cartridge produces into that virtual short. No need to worry about or fuss around with loading choices.

Sutherland Little LOCO Mk2 phono preamplifier open top

Sutherland Little Loco Mk2 SPECIFICATIONS
—

SIZE:

  • 17” wide
  • 13” deep
  • 2″ high

WEIGHT

  • 15 lbs.

WARRANTY:

5 years parts and labor. Transferable. Only valid for units that have not been modified or abused.

Hear Sutherland at Command Performance today!